Spring-Loaded Turnover Bars

Turnover Bar

In OSHA 29 CFR 1910.217, it says that "The employer shall provide spring-loaded turnover bars for presses designed to accept such turnover bars."

The turnover bar is most frequently used with mechanical power presses. Turnover bars can also be used on four-slides or any other machine where the bar might be sent into the air if it is inadvertently left in the bar ring hole and the machine is turned on. Each spring-loaded turnover bar is self-ejecting so it can't be left in the bar hole.

Part No. Nominal
Size		 Actual
Size		 Bar
Diameter		 Outside Diameter Engagement
Length		 Overall
Length		 Weight in
Pounds
KMR-001 3/8" .365" 19/32" 1.050" 1.5" 18" 1.8
KMR-002 1/2" .490" 3/4" 1.050" 1.75" 24" 3.5
KMR-003 5/8" .615" 3/4" 1.050" 1.75" 24" 3.5
KMR-004 3/4" .740" 15/16" 1.315" 2.00" 30" 6.7
KMR-005 7/8" .865" 15/16" 1.315" 2.00" 30" 6.7
KMR-006 1" .990" 1 1/4" 1.660" 2.50" 36" 13.7
KMR-007 1 1/4" 1.240" 1 1/4" 1.660" 2.50" 36" 14.0

Each engaging bar is made .010" under corresponding hole size. End is chamfered for easy entry. Consult the factory for special sizes.

Ordering Information

Part #   Description   Price   Qty.    
KMR-001   3/8" SPRING-LOADED TURNOVER BAR   $125.00    
KMR-002   1/2" SPRING-LOADED TURNOVER BAR   $160.00    
KMR-003   5/8" SPRING-LOADED TURNOVER BAR   $160.00    
KMR-004   3/4" SPRING-LOADED TURNOVER BAR   $170.00    
KMR-005   7/8" SPRING-LOADED TURNOVER BAR   $170.00    
KMR-006   1" SPRING-LOADED TURNOVER BAR   $200.00    
KMR-007   1 1/4" SPRING-LOADED TURNOVER BAR   $200.00    
The products and photos on this site are carefully checked for accuracy; however some cosmetic differences may occur.